Hello all,
Can you guys help me to check if I labeled all the quantities and had my equations set up correctly? I think I have I_5 wrong, but Im not sure. The question is to calculate the power deliv
For most mousetrap car designs, the length of the axle isnt a concern.For distance where time is not a concern, the diameter of the axle should be as small as possible (and the wheels as large as poss
Hey all, I was wondering if this was a rewarding and interesting field to go into. From what Ive read, and my understanding the differences between Engineering Technologists and Engineers are that one
What is the equivalent resistance of a 15.0 ohm and a 26.0 ohm resistor connected in series? How much current would a 12.0 battery deliver to the resistor network, and what is the voltage drop across
please im doin aircraft engineering with pilot studies , so please some one guide me by giving good details about aircraft maintenance engineering and regarding the requirements , as i heard it is hig
a power amplifier, like any amplifier, does not distort signals by much unless the max input is exceeded. If it is, the type of distortion depends on the design, but in general, it will clip the top a
Valerie Thomas
Inventor of the Illusion Transmitter
From 1964 to 1995, Thomas worked in a variety of capacities for NASA where she developed real-time computer data systems, conducted large-scale exp
fill the tank if both pipes are working together? Write answer in hours and minutes. Thanks!-1 tank filled = (time / 240 min) + (time / 360 min)
1 = t/ 240 min + t/360 min
1/t = 3 /720 min + 2 /720 m
I do not use resistors to connect CMOS/HC inputs to ground or supply. Is that required with HCT?
What kind of resistor should I use?-You should be safe with a ground connection to an INPUT.
See http://www.dccoil.com/page.asp?p_key=A73…
WHich I found from
http://www.thomasnet.com/productsearch/r…
http://www.hardwareproducts.com/21002-14…
http://www.sctco.com/Barber-Spring.htm
Otherwise
I have a formula for power output of an engine
P=2.pie.N.T
I am slightly confused on the N value, it is rotational speed.
I have a set of data for speed in r.p.m should i convert this to r.p.s and
I am working with capacitors and I have two in a serious. In between the capacitors I end up with a charge. I know because after unhooking them, and then testing voltage it shows power. Anyways my que