I am a practicing electrical engineer in the power industry.Recently at a kickoff meeting, another engineer mentioned that there was the need to bring in a natural gas line at 2-5psi and 4,000,000 Btu
1. What its made of..eg copper, gold
2. Cross section (diameter)
3. Length
4. Loops, bends, nicks
bonus :5. Temperature-1 material - Copper will have less resistant than steel.
2 length - Longer wire
Can someone please explain his principle in a way that a 10 yrs old can understand?-Please specify if for gears, pulleys, levers, volumetric displacement, etc
Archimides had much to say about everythi
Consider the RL circuit in the diagram below with the following component values.R = 117 ohmsL = 328 millihenries
and Vs undergoes a step change at t=0
Vs(t) = 0 volts for tVs(t) = 6 volts for t>0
W
Both are similar in that they both use a fluid pressure to do work.
However where oils (or water) are nearly incompressible and will transmit forces very similar to what is applied, the compressibilit
Hi all,
I have a graph of points using
plot(p1x,p1y,X)
hold on;
plot(p2x,p2y,X)
plot(p3x,p3y,X)
plot(p4x,p4y,X)
hold off;
title()
xlabel()
ylabel()
grid
but i want to have a line from (0,0) to the
A tuyere is a tube, nozzle or pipe through which air is blown into a furnace or hearth.[1]
Air or oxygen is injected into a hearth under pressure from bellows or a blast engine or other devices. This
I have a bunch of variable air capacitors. I want to find out how I can figure out their range. I think if I measure the plates, spacing, and amount of plates, I can figure out the rating. Is there an
It allows a lightening strike to take an easy route to earth rather than causing damage or injury. It is made from a good conducting metal and can be found on tall buldings (quite often churches). The
Resistance to the positive side of the power supplies is not an issue with regular traces, so logically the same would be true of the ground side as well.Why use an entire plane for the ground supply
If I were to research on making a perpetual motion machine, which branch of physics should i mainly concentrate on?-You should research physics and thermodynamics, but both of those branches state tha
We are treding on ground I know little about, but maybe the venturi principle... Make the pipe smaller, the flow will increase in speed, then lower the pressure until you return to normal.-In theory y
Osmium or Iridium depending on who you believe.
Osmium wins because the specific gravity of Iridium is very slightly lower than Osmium.
Density, or volumic mass, is a measure of mass per unit of vol
