To press a 2 inch diameter shaft 2 inches deep into a gear and not require more than 6 tons pressing force

Favorites|Homepage
Subscriptions | sitemap

HOME > Engineering > To press a 2 inch diameter shaft 2 inches deep into a gear and not require more than 6 tons pressing force

To press a 2 inch diameter shaft 2 inches deep into a gear and not require more than 6 tons pressing force

[From: ] [author: ] [Date: 11-05-17] [Hit: ]

http://www.engineersedge.com/manufacturi…-I might not understand your question correctly. I have put piston sleeves in by using a carbon dioxide bottle. The idea is to open the valve and saturate the object being inserted with CO2 thus cooling it and shrinking it enough to allow it to smoothly go into the space. After it returns to normal temp you will have a snug fit.......

What interference fit would be required?

-

See the following websites::

http://www.engineersedge.com/bearing/bus…

http://www.engineersedge.com/manufacturi…

-

I might not understand your question correctly. I have put piston sleeves in by using a carbon dioxide bottle. The idea is to open the valve and saturate the object being inserted with CO2 thus cooling it and shrinking it enough to allow it to smoothly go into the space. After it returns to normal temp you will have a snug fit.

1

keywords: gear,more,into,and,shaft,not,force,press,diameter,deep,inches,tons,pressing,require,inch,To,than,To press a 2 inch diameter shaft 2 inches deep into a gear and not require more than 6 tons pressing force

New

Hot